1,000 Sq Ft Architectural Shingle Roof Cost (2026)
A 1,000 sq ft architectural shingle roof runs about $4,110 to $6,910 installed in Florida (2026), or $1,370 to $1,570 for materials only.
$411 to $691 per roofing square, from real Florida pricing (retailer pricing at ZIP 33101 plus RoofingCalc installed ranges).
| Materials | $1,370 to $1,570 Architectural Shingle and accessories for about 10 squares. |
| Labor | $1,700 to $3,310 Crew, install, and staging. The largest share of most jobs. |
| Tear-off and disposal | $710 to $1,390 Stripping the old roof and hauling it off. Rises with extra layers. |
| Permit and inspection | $330 to $640 Florida re-roof permit and final inspection. An approximate derived share. |
| Total installed | $4,110 to $6,910 Typical $5,510. Low, typical, and high across a normal range of roofs. |
Scaled from real Florida per-square pricing off a 30-square baseline; the permit share is an approximate derived figure. How we estimate →
What affects the cost of a 1,000 sq ft roof.
A 1,000 sq ft roof is about 10 roofing squares, one of the smaller jobs a Florida crew takes on. The price per square usually runs higher than it does on a large house, because the fixed parts of any re-roof do not shrink with the roof. Mobilizing the crew, pulling the permit, renting the dumpster, and hitting the contractor's minimum day all cost roughly the same whether the roof is 1,000 or 2,000 square feet, so on a small roof those costs spread across fewer squares.
At this size, complexity moves the total more than square footage does. A steep, cut-up 1,000 sq ft roof with valleys, dormers, and a second story can take as much labor as a simple 1,400 sq ft single-story ranch. Tear-off is the other swing factor: stripping two layers of old shingle roughly doubles the disposal weight and the dump fees, and it is common on older Florida homes that were overlaid once already.
Every Florida re-roof pulls a permit and a final inspection, and the building code requires a rated underlayment and a secondary water barrier in the wind zone, which is built into these ranges. Because the estimate scales linearly off a 30-square baseline, a small roof sits at the least accurate end of that model. Treat the number as a research starting point and get a measured quote before you budget.
Other sizes · Architectural Shingle
All roof costsA 1,000 sq ft architectural shingle roof costs about $4,110 to $6,910 installed in Florida in 2026, with a typical price near $5,510, or roughly $411 to $691 per roofing square. Architectural (dimensional) shingles cost more than entry-grade asphalt but carry longer warranties and higher wind ratings, which matters in Florida.
A 1,000 sq ft roof is about 10 roofing squares. Roof area runs larger than a home's floor area because it follows the pitch and the overhangs, so a 1,000 sq ft roof does not mean a 1,000 sq ft house. Contractors price by the square, so the roof's square footage is the number that drives an architectural shingle estimate.
An architectural (dimensional) shingle roof typically lasts about 20 to 30 years in Florida, longer than entry-grade asphalt on the same 1,000 sq ft roof. The heavier shingle and higher wind rating hold up better against the state's sun and storms, and a newer, higher-rated roof is also easier to insure and can earn wind-mitigation credits.
Florida homeowners insurance covers roof replacement when the damage is from a covered peril such as wind or hail, not from age and wear. A 1,000 sq ft architectural shingle roof runs about $4,110 to $6,910, and because carriers weigh roof age heavily, an older roof may raise premiums or require replacement before a policy is written. A wind-mitigation inspection on an architectural roof often lowers the premium.
Price your roof.
Get a budget estimate for your exact home, then see a new roof on it.