1,000 Sq Ft Tile Roof Cost (2026)
A 1,000 sq ft tile roof runs about $7,000 to $15,000 installed in Florida (2026), or $3,000 to $6,000 for materials only.
These tile figures are an industry-reference estimate. Florida-specific pricing for this material is being sourced and will replace the placeholder ranges.
$700 to $1,500 per roofing square. Industry-reference estimate (Homewyse and RoofingCalc typical); Florida-specific pricing pending.
| Materials | $3,000 to $6,000 Tile and accessories for about 10 squares. |
| Labor | $2,480 to $5,580 Crew, install, and staging. The largest share of most jobs. |
| Tear-off and disposal | $1,040 to $2,340 Stripping the old roof and hauling it off. Rises with extra layers. |
| Permit and inspection | $480 to $1,080 Florida re-roof permit and final inspection. An approximate derived share. |
| Total installed | $7,000 to $15,000 Typical $11,000. Low, typical, and high across a normal range of roofs. |
Scaled from real Florida per-square pricing off a 30-square baseline; the permit share is an approximate derived figure. How we estimate →
What affects the cost of a 1,000 sq ft roof.
A 1,000 sq ft roof is about 10 roofing squares, one of the smaller jobs a Florida crew takes on. The price per square usually runs higher than it does on a large house, because the fixed parts of any re-roof do not shrink with the roof. Mobilizing the crew, pulling the permit, renting the dumpster, and hitting the contractor's minimum day all cost roughly the same whether the roof is 1,000 or 2,000 square feet, so on a small roof those costs spread across fewer squares.
At this size, complexity moves the total more than square footage does. A steep, cut-up 1,000 sq ft roof with valleys, dormers, and a second story can take as much labor as a simple 1,400 sq ft single-story ranch. Tear-off is the other swing factor: stripping two layers of old shingle roughly doubles the disposal weight and the dump fees, and it is common on older Florida homes that were overlaid once already.
Every Florida re-roof pulls a permit and a final inspection, and the building code requires a rated underlayment and a secondary water barrier in the wind zone, which is built into these ranges. Because the estimate scales linearly off a 30-square baseline, a small roof sits at the least accurate end of that model. Treat the number as a research starting point and get a measured quote before you budget.
A 1,000 sq ft tile roof costs about $7,000 to $15,000 installed in Florida in 2026, with a typical price near $11,000, or roughly $700 to $1,500 per roofing square. Concrete and clay tile cost more than shingles, partly because the heavier material needs adequate roof structure. These figures are an industry-reference estimate; Florida-specific tile pricing is being finalized.
A 1,000 sq ft roof is about 10 roofing squares. Roof area is larger than a home's floor area because it follows the pitch and overhangs, so a 1,000 sq ft roof does not mean a 1,000 sq ft house. Tile is priced by the square, so the roof's square footage drives the estimate.
A concrete or clay tile roof typically lasts 50 years or more in Florida, well beyond an asphalt roof on the same 1,000 sq ft home. Tile is common across Florida for its longevity and heat resistance, though the underlayment beneath it usually needs replacing sooner than the tile itself.
Florida homeowners insurance covers roof replacement when the damage is from a covered peril such as a hurricane or hail, not from age and wear. A 1,000 sq ft tile roof runs about $7,000 to $15,000, and while tile lasts a long time, carriers still weigh the age of the roof and its underlayment when pricing or writing a policy.
Price your roof.
Get a budget estimate for your exact home, then see a new roof on it.